Heater Tune Up

12 Point Precision Oil Heater Tune-up

Our oil heater tune-up includes the following:

  • Clean heating unit, vent pipe and chimney base.
  • Adjust burner for maximum efficiency.
  • Clean and adjust electrode and nozzle assembly.
  • Lubricate all motors, bearings, fans and circulators.
  • Replace oil nozzle and oil filter.
  • Test and adjust all safety and operating controls.
  • Inspect flue pipe, barometric damper and combustion chamber.
  • Test oil pump operation.
  • Change air filter(s), if applicable.
  • Check oil tank and lines.
  • Inform customer of equipment condition.
  • Leave record of efficiency results.

15 Point Precision Gas Heater Tune-up

Our gas heater tune-up includes the following:

  • Test carbon monoxide levels.
  • Clean and adjust burners and inspect heat exchanger.*
  • Check thermostat operation.
  • Lubricate all motors, bearings, fans and circulator pumps.*
  • Clean pilot assembly.
  • Install one 1-inch filter.
  • Test and adjust operation of safety and operating controls.
  • Inspect flue pipe and gas valve.
  • Check blower motor (and belt if applicable)
  • Test and tighten all wiring and connections.
  • Turn exposed dampers to heating position if marked (no balancing)
  • Flush condensate drain to protect overflow.*
  • Check temperature rise.
  • Check fan speeds.
  • Check gas pressure at gas valve.
  • Inform customer of equipment condition. Recommend necessary repairs.

* If equipped